康明斯发动机机油消耗高故障诊断及排除

康明斯发动机机油消耗高故障需按以下步骤处理。 

故障原因                                                                                       措施

1、机油泄漏（外部）                                            检查发动机是否存在外部机油泄漏。拧紧螺栓、管接头和管塞。O                                                                          如有必要更换密封垫。

2、进气系统超出阻力规范。                                 检查进气系统阻力，如有必要更换空滤。

3、机油标尺标定不正确。

4、曲轴箱通风系统堵塞引起曲轴箱压力高，     检查并清洁曲轴箱呼吸器管。

     油封总处于压力环境，造成密封性变差，

     在压力作用下机油泄漏。

5、涡轮增压器油封渗漏                                        检查压气机油封。

6、气门导杆密封泄漏                                            检查气门导杆油封，如有必要则更换。

7、活塞环磨损                                      检查串气量是否过

Cummings engine oil consumption high fault diagnosis and exclusion

Cummings engine oil consumption high fault processing according to the following steps.

Fault measures

1, the oil leakage (external) to check whether the engine external oil leakage. Tighten the bolts, pipe fittings and pipe plug. O if necessary, replace the gasket.

Resistance standard beyond 2, the intake system. Check the intake resistance, replace the air filter if necessary.

3, oil scale calibration is not correct.

Cause the crankcase pressure high block 4, the crankcase ventilation system, check and clean the crankcase ventilation tube.

In the total pressure caused by oil seal, seal variation,

Leakage oil under pressure.

5, the turbocharger oil seal leakage check compressor oil seal.

6, valve stem seal leakage check valve stem oil seal, replace if necessary.

7, check whether the amount of gas piston ring wear.